Dakota 4WD V8-4.7L Flex Fuel (2008)
1. Unlatch and open the access door (4) on the cab back trim panel (2) to access the tether anchor (1).
2. Remove the screw (5) that secures the child tether anchor to the upper cab back panel reinforcement (3).
3. Remove the child tether anchor from the cab back.
Tether Strap - Club Cab
TETHER STRAP - CLUB CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The following procedure applies only to the right outboard rear seat upper child tether strap used on club cab vehicles equipped with
optional rear seats.
1. Fold down the right outboard rear seat upper back pad (4) from the cab back trim panel (2) to access the tether strap (1).
2. Remove the screw (5) that secures the child tether strap to the upper cab back panel reinforcement (3).
3. Remove the child tether strap from the cab back.
Tether Strap - Quad Cab
TETHER STRAP - QUAD CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
