Dakota 4WD V8-4.7L Flex Fuel (2008)
Child Seat Tether Attachment: Service and Repair
Installation
Rear Seat Lower Anchor Bracket - Club Cab
REAR SEAT LOWER ANCHOR BRACKET - CLUB CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The following procedure applies only to the lower anchor bracket used in the right rear seating position of club cab vehicles.
1. Position the lower anchor bracket (4) to the floor panel and the cab back panel (2) under the right rear seat cushion.
2. Loosely install the two screws (3) that secure the bracket to the cab back panel.
3. Install and tighten the two screws (1) that secure the bracket to the floor panel. Tighten the screws to 3 Nm (30 in. lbs.).
4. Tighten the two screws that secure the bracket to the cab back panel. Tighten the screws to 23 Nm (17 ft. lbs.).
5. Restore the floor carpet under the rear seat cushion to the base of the cab back panel.
Tether Anchor - Club Cab
TETHER ANCHOR - CLUB CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The following procedure applies only to the center upper child tether anchor used on all club cab vehicles.
