Dakota 4WD V8-4.7L Flex Fuel (2008)
12. Position the seat belt (1) lower anchor to the mounting hole on the outboard side of the front seat cushion frame (2). Be certain that the seat belt
webbing between the turning loop and the lower anchor is not twisted.
13. Install and tighten the screw (3) that secures the lower anchor to the seat. Tighten the screw to 39 Nm (29 ft. lbs.).
14. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests.
Rear Center - Quad Cab
REAR CENTER - QUAD CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The right side of the rear center seat belt and retractor mounting bracket and the unique, keyed center seat belt lower anchor
buckle/right outboard occupant buckle unit are secured to the rear floor by a common screw, but the lower anchor buckle and the right
outboard occupant buckle can be removed from the mounting bracket and are serviced separately from the seat belt and retractor. The center
anchor buckle and the right outboard occupant buckle are serviced as a unit with their anchor brackets. See: Seat Belt Buckle/Service and
Repair/Seat Belt Buckle - Installation.
