Dakota 4WD V8-4.7L Flex Fuel (2008)
8. Reinstall the upper trim (2) onto the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Installation.
9. Position the seat belt turning loop to the mounting hole in the upper C-pillar.
10. Install and tighten the screw (5) that secures the seat belt turning loop to the C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
11. Engage the tab on the lower edge of the trim cover (4) in the slot below the screw in the turning loop. Then press the upper edge of the trim cover
over the top of the turning loop until it snaps into place.
Rear Outboard - Quad Cab
REAR OUTBOARD - QUAD CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Position the rear seat belt and retractor (2) to the inner C-pillar (1).
2. Engage the tab on the back of the retractor into the T-slot in the inner C-pillar.
3. Install and tighten the screw (3) that secures the retractor to the inner C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
4. Route the seat belt, lower anchor, latch plate (7) and turning loop (4) through the clearance holes in the lower C-pillar trim (3). Be certain that the
seat belt webbing between the retractor and the lower anchor is not twisted.
5. Position the seat belt lower anchor to the mounting hole near the base of the inner C-pillar (1).
6. Install and tighten the screw (8) that secures the lower anchor to the inner C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
7. Reinstall the lower trim onto the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Installation.
