Dakota 4WD V8-4.7L Flex Fuel (2008)
4. Remove the two plastic push-pin retainers (2) that secure the trim cover (1) to the retractor (3) on the floor panel near the door sill.
5. Raise the trim cover up off of the retractor far enough to disengage the two locator pins in the top of the inboard cover half from the locator holes
in the top of the retractor.
6. Spread apart the lower end of the inboard (1) and outboard (3) trim cover halves far enough to release the snap features that secure the tops of the
two halves to each other.
7. Remove the trim cover halves from around the seat belt and retractor (2).
8. Loosen and move aside the front (5) and rear (4) scuff plates from the door sill far enough to access the retractor mounting bracket. See: Body and
Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Door Sill Scuff Plate - Removal.
9. Disconnect the body wire harness connector (3) from the seat belt tensioner initiator on the retractor (1).
10. Remove the two screws (2) that secure the retractor mounting bracket to the floor panel inboard of the door sill (4).
