Dakota 4WD V8-4.7L Flex Fuel (2008)
Suspension Spring ( Coil / Leaf ): Service and Repair
Front Suspension
Front Spring - Removal
REMOVAL
1. Remove the shock See: Suspension Strut / Shock Absorber/Service and Repair/Front Strut / Shock/Removal.
2. Install the shock assembly in the Branick 7200(R) spring removal/installation tool or equivalent (1).
3. Compress the spring (2).
4. Position shock nut wrench 9362 (2), on shock shaft retaining nut. Next, insert 8 mm socket though Wrench onto hex located on end of shock shaft.
While holding shock shaft from turning, remove nut from shock shaft using Wrench.
5. Remove the upper shock nut.
6. Remove the shock.
7. Remove the shock upper mounting plate.
8. Remove and inspect the upper and lower spring isolators.
Front Spring - Installation
INSTALLATION
