Dakota 4WD V8-4.7L Flex Fuel (2008)
Wheel Bearing: Service and Repair
Front Hub / Bearing - Removal
REMOVAL
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the brake caliper and rotor See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Removal.
4. Remove the ABS wheel speed sensor if equipped, See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Front Wheel Speed Sensor - Removal.
5. Remove the halfshaft nut 4X4 only.
NOTE: Do not strike the knuckle with a hammer to remove the tie rod end or the ball joint. Damage to the steering knuckle will occur.
6. Pull down on the steering knuckle to separate the halfshaft from the hub/bearing. 4X4 only
7. Remove the three hub/bearing mounting bolts (3) from the steering knuckle (4).
8. Slide the hub/bearing (1) out of the steering knuckle (4).
9. Remove the brake dust shield (5).
