Dakota 4WD V8-4.7L Flex Fuel (2008)
1. Using Installer 10118 (1) and Handle C-4171, install the front input shaft seal.
2. Install the transfer case into the vehicleSee: Service and Repair/Removal and Replacement/Transfer Case - Installation
Removal
REMOVAL
1. Raise vehicle.
2. Remove rear propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Rear
3. Using a suitable pry tool or slide-hammer mounted screw, remove the rear case extension seal.
Installation
INSTALLATION
NOTE: Lubricate all seals with MOPAR(R) ATF+4 prior to installation.
1. Clean fluid residue from sealing surface and inspect for defects.
2. Using Installer D-163 (2) and Handle C-4171 (1), install the new seal into the rear case extension.
3. Install the rear propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement/Rear
4. Verify proper fluid level.
5. Lower vehicle.
Removal
REMOVAL