Dakota 4WD V8-4.7L Flex Fuel (2008)
5. Position windshield (1) in center of windshield opening and resting on the side and lower spacers (2).
6. Adjust the lower spacers (2) as required, to center the windshield in the windshield opening.
7. Apply adhesive tape (1) to the locations shown to aid with final installation.
8. Verify windshield gap is parallel to with windshield.
9. Cut tape with a sharp knife and remove windshield.
NOTE: Typical primer installation shown.
10. Clean and dry area of glass (2) to be re-glued with a suitable glass preparation solvent and rag.
11. Using a flash light, verify that glass primer is without damage.
12. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.