Dakota 4WD V8-47L Flex Fuel (2008) | Windshield Removal | Service and Repair
13. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.) (2).
14. Allow primer to air dry for at least 10 minutes.
15. Using a flash light, verify that glass primer is without damage.
Windshield Preparation - Installing A New Windshield
1. Apply four new spacers (1) to the a-pillars and place them evenly apart at the top and bottom.
2. Install the lower spacer assemblies (2) into the slotted holes and verify proper installation by pulling to make sure they are locked on.
NOTE: Lower spacers must be facing with the flat side upwards when installing into the slotted holes.
3. Position windshield (1) in center of windshield opening and resting on the side and lower spacers (2).
4. Adjust the lower spacers (2) as required, to center the windshield in the windshield opening.
