Dakota 4WD V8-4.7L Flex Fuel (2008)
5. Clean and check windshield for damage.
6. Position windshield in center of windshield opening.
7. Apply adhesive tape to the locations shown to aid with final installation.
8. Verify windshield gap is parallel to with windshield.
9. Cut tape with a sharp knife and remove windshield.
10. Clean and dry area of glass to be glued with a suitable glass preparation solvent and rag.
11. Apply primer to gluing surface at windshield seal.
12. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.) (2).
13. Allow primer to air dry for at least 10 minutes.
14. Using a flash light, verify that glass primer is without damage.
Windshield Opening Preparation
