Dakota 4WD V8-4.7L Flex Fuel (2008)
Wiper Motor: Service and Repair
Wiper Module - Installation
INSTALLATION
1. Position the wiper module (3) into the cowl plenum (1) as a unit.
2. Reconnect the headlamp and dash wire harness connector (4) to the wiper motor pigtail wire connector.
3. Loosely install the four screws (2) that secure the wiper module to the cowl plenum panel.
4. Tighten the screws that secure the wiper module near the pivot brackets, driver side first followed by the passenger side. Tighten the screws to 8
Nm (72 in. lbs.).
5. Tighten the screws that secure the wiper module near the motor bracket, passenger side first followed by the driver side. Tighten the screws to 8
Nm (72 in. lbs.).
6. Reinstall the cowl plenum cover/grille panel over the cowl plenum. See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Cowl
Top Panel - Installation.
7. Reconnect the battery negative cable.
8. Close and latch the hood.
9. Reinstall both wiper arms onto the wiper pivots. See: Wiper Arm/Service and Repair/Wiper Arms - Installation.
