Dakota 4WD V8-4.7L VIN J (2007)
Front Bumper Reinforcement: Service and Repair
Support-Front Fascia
Removal
REMOVAL
1. Remove the support bracket.
2. Remove the four nuts (1 and 3) securing the fascia support (4) to the frame tips (2).
3. Remove the support (4).
Installation
INSTALLATION
1. Install the fascia support (4) and install the right (1) and left (3) nuts.
2. Tighten the nuts to 95 Nm (70 ft. lbs.).
3. Install the fascia support bracket.
4. Check front fascia gap and flush positioning. Refer to Body and Frame / Specifications.
5. Loosen the nuts (1 and 3) and adjust the front fascia to specifications.