Dakota 4WD V8-4.7L VIN J (2007)
Seat Track: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the driver side seat assembly from the vehicle.
3. Disconnect the power seat wire harness connectors.
4. Disconnect the power seat wire harness retainers from the seat track assembly.
5. Remove the four bolts that secure the power seat track assembly to the seat cushion frame.
6. If the vehicle is equipped with a split bench seat, remove the fasteners that secure the center seat cushion section to the brackets on the power seat
track assembly.
7. Remove the power seat track assembly from the seat cushion frame.
CAUTION: Before installing the seat into the vehicle, be certain to adjust the seat fully rearward on its tracks. Then install and tighten
the front track mounting screws before installing the rear screws or the tracks may be damaged.
