Dakota 4WD V8-4.7L VIN J (2007)
INSTALLATION
1. Position the recirculation door actuator (1) onto the air inlet housing (2). If necessary, rotate the actuator slightly to align the splines in the
recirculation-air door pivot shaft (3) with those on the actuator output shaft (4).
2. Install the three screws (1) that secure the recirculation door actuator (2) to the air inlet housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
3. Position the air inlet housing (2) onto the top of the HVAC housing (6).
4. Install the four screws (4) that secure the air inlet housing to the top of the HVAC housing. Tighten the screws to 2 Nm (17 in. lbs.).
5. Connect the HVAC wire harness (5) to the recirculation door actuator (1) and the blower motor resistor (3).
