Dakota 4WD V8-4.7L VIN J (2007)
The club cab right outboard front seat upper tether anchor (3) is integral to the front seat cushion (2) frame. This anchor is constructed from round steel
bar stock that is formed into a loop, then securely welded at each end to the seat cushion frame. It is accessed from behind the front seat, just below the
seat back (1). This anchor cannot be adjusted or repaired and, if ineffective or damaged, it must be replaced as a unit with the seat cushion frame.
The club cab right outboard front seat lower anchors (2) are also integral to the front seat cushion frame. These lower anchors are each constructed from
round steel bar stock that is formed into a loop, then securely welded at each end to the seat cushion frame. They are each accessed from the front of the
seat, at each side where the seat back (1) meets the seat cushion (3). These lower anchors cannot be adjusted or repaired and, if ineffective or damaged,
they must be replaced as a unit with the seat cushion frame.
The right outboard rear seat upper tether strap and center anchor for club cab vehicles are secured to the upper cab back panel reinforcement with screws
and are concealed behind the cab back trim (3). The outboard tether strap is accessed by folding down the right upper rear seat back pad (1), while a
hinged access door (2) is opened to access the center anchor. This upper tether strap and the anchor are available for individual service replacement.
