Dakota 4WD V8-4.7L VIN J (2007)
1. Position the seat belt turning loop and height adjuster (3) bracket to the mounting holes in the upper roof rail (1).
2. Install and tighten the two screws (2) that secure the seat belt turning loop and height adjuster bracket to the upper roof rail. Tighten the screws to
39 Nm (29 ft. lbs.).
3. Position the trim cover (3) to the headliner (2) opening around the door striker and the seat belt turning loop adjuster bracket on the upper roof rail
(1).
4. Using hand pressure, press firmly and evenly on the trim cover until the two snap clips that secure it to the upper roof rail snap into place.
5. Position the retractor (1) mounting bracket to the mounting holes in the floor panel inboard of the door sill (4). Be certain that the seat belt
webbing between the retractor and the turning loop is not twisted.
6. Install and tighten the two screws (2) that secure the retractor bracket to the floor panel. Tighten the screws to 39 Nm (29 ft. lbs.).
