Dakota 4WD V8-4.7L VIN J (2007)
7. Reconnect the body wire harness connector (3) to the seat belt tensioner initiator on the retractor.
8. Restore the front (5) and rear (4) scuff plates to the door sill over the retractor mounting bracket.
9. Position the inboard (1) and outboard (3) trim cover halves around the seat belt and retractor (2) with the lower end spread open far enough to
engage the snap features that secure the tops of the two halves to each other.
10. Close the lower ends of the trim cover halves together.
11. Using hand pressure, push the trim cover (1) down over the retractor (3) far enough to engage the two locator pins in the top of the inboard cover
half with the locator holes in the top of the retractor.
12. Reinstall the two plastic push-pin retainers (2) that secure the trim cover to the retractor.
