Dakota 4WD V8-4.7L VIN J (2007)
Seat Belt Retractor: Service and Repair
Installation
Front Outboard - Club Cab
FRONT OUTBOARD - CLUB CAB
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The following procedure is for replacement of an ineffective or damaged seat belt and retractor unit. The front retractor also includes a seat belt
tensioner. If the front seat belt or retractor is ineffective or damaged, but the seat belt tensioner is not deployed, review the recommended procedures for
handling non-deployed supplemental restraints. If the seat belt tensioner has been deployed, review the recommended procedures for service after a
supplemental restraint deployment before removing the unit from the vehicle.
1. Position the seat belt turning loop and height adjuster (3) bracket to the mounting holes in the upper roof rail (1).
2. Install and tighten the two screws (2) that secure the seat belt turning loop and height adjuster bracket to the upper roof rail. Tighten the screws to
39 Nm (29 ft. lbs.).
