Dakota 4WD V8-4.7L VIN J (2007)
Hood Sensor/Switch (For Alarm): Service and Repair
Removal
REMOVAL
1. Unlatch and open the hood.
2. Disconnect and isolate the battery negative cable.
3. From the top of the left outboard end of the cowl plenum cover/grille panel, squeeze the two hood ajar switch latch tabs (2) together and pull the
switch upward out of the mounting hole (1).
4. Pull the hood ajar switch up through the mounting hole far enough to access and disconnect the wire harness connector (3) from the switch
connector receptacle.
5. Remove the hood ajar switch from the vehicle.
