Dakota 4WD V8-4.7L VIN J (2007)
Gear Sensor/Switch: Description and Operation
NV233 Transfer Case
Description
DESCRIPTION
The transfer case mode sensor (1) provides the Front Control Module (FCM) feedback about the position of the transfer case. The sensor consists of a
linear analog position sensor that converts the motor output shaft position into a DC signal. The FCM must supply 5VDC (+/- 0.5v) to the sensor
whenever the FCM is not in sleep mode and monitor the shift motor position. The sensor position is monitored when the ignition is in the RUN position
and for 10 seconds after the ignition is shifted to the OFF position. The sensor is mechanically linked to the shaft of the cam which allows the transfer
case to shift. The mode sensor will draw less than 20 mA of current during operation.
Operation
OPERATION
During normal vehicle operation, the Front Control Module (FCM) monitors the mode sensor outputs at least every 2 milliseconds when the shift motor
is stationary or active.
Refer to for the relative angles of the transfer case shift sector versus the interpreted transfer case gear operating mode.
Sector Angles vs. Transfer Case Position
NOTE: All the parameter voltages referred to in the following information are calibrated items in the controller software and are subject to
change.
