Dakota 4WD V8-4.7L VIN N (2000)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Four Wheel Antilock Brake System
NOTE: If the antilock control assembly needs to be replaced, the rear axle type and tire revolutions per mile must be programmed into the new CAB.
For axle type refer to Transmission and Drivetrain, Differential. For tire revolutions per mile refer to Steering and Suspension, Tires, Wheels and
Alignment. To program the CAB refer to Testing and Inspection, Procedures, Diagnostic Information and Procedures.
REMOVAL
1. Disconnect battery negative cable.
HCU Brake Lines
2. Remove the brake lines from HCU.
3. Push the harness connector locks to release the locks, then remove the connectors from the CAB.
