Dakota 4WD V8-4.7L VIN N (2000)
4. Install caliper spring into one caliper hole and under the adapter. Pull down on the opposite end of the spring and hold the end under the adapter.
With a screw driver pry up on the spring to seat the spring into the other caliper hole.
NOTE: Verify the spring is seated properly into the caliper holes.
5. Install brake hose to caliper with new seal washers and tighten fitting bolt to 24 Nm (18 ft. lbs.).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
6. Bleed base brake system.
7. Install wheel and tire assemblies.
8. Remove supports and lower vehicle.
9. Pump brake pedal to seat brake shoes.
10. Fill brake fluid reservoir.
11. Verify firm pedal before moving vehicle.
