Dakota 4WD V8-4.7L VIN N (2000)
Cruise Control Servo: Service and Repair
REMOVAL
1. Disconnect negative battery cable at battery.
Speed Control Servo Location
2. Disconnect vacuum hose (line) at servo.
3. Disconnect electrical connector at servo.
4. Disconnect servo cable at throttle body. Refer to Servo Cable Removal/installation.
Servo Cable Clip Remove/Install - Typical
5. Remove 2 mounting nuts holding servo cable sleeve to bracket.
6. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip ]and remove clip. Note: The servo
mounting bracket displayed in is a typical bracket and may/may not be applicable to this model vehicle.
7. Remove servo from mounting bracket. While removing, note orientation of servo to bracket.
INSTALLATION
1. Position servo to mounting bracket,