Dakota 4WD V8-4.7L VIN N (2000)
8. Remove the lower ball joint cotter pin and nut. Separate the ball joint from the knuckle with Remover C-4150A and remove the knuckle.
9. Remove the hub/bearing from the steering knuckle.
INSTALLATION
1. Install the hub/bearing to the steering knuckle and tighten the bolts to 166 Nm (123 ft. lbs.).
NOTE: When installing hub/bearing with ABS brakes, position the speed sensor opening towards the front of the vehicle.
CAUTION: The ball joint stud tapers must be CLEAN and DRY before installing the knuckle. Clean the stud tapers with mineral spirits to
remove dirt and grease.
2. Install the knuckle onto the upper and lower ball joint.
3. Install the upper and lower ball joint nuts. Tighten the upper ball joint nut to 81 Nm (60 ft. lbs.) and the lower ball joint nut to 183 Nm (135 ft.
lbs.) then install cotter pins. Grease the lower ball joint.
4. Remove the hydraulic jack from the lower suspension arm.
5. Install the tie rod end and tighten the nut to 88 Nm (65 ft. lbs.). Install the cotter pin.
6. Install the front driveshaft.
7. Install the ABS wheel speed sensor if equipped and brake shield, rotor and caliper.
8. Install the wheel and tire assembly.
9. Remove support and lower the vehicle.
