Service and Repair for Front Axle C205F's Pinion Gear in Dakota 4WD V8-47L VIN N (2000)
Fig. 25
7. Install seal with Installer C-3972-A and Handle C-4171 (Fig. 25).
NOTE: Pinion depth shims are placed between the rear pinion bearing cone and pinion gear head to achieve proper ring gear and pinion mesh. If
the factory installed ring gear and pinion are reused, the pinion depth shim should not require replacement. If required, refer to Pinion Gear Depth
to select the proper thickness shim before installing rear pinion bearing.
8. Place the proper thickness depth shim on the pinion shaft.
Fig. 26
9. Install the rear bearing and slinger, if equipped, onto the pinion shaft with Installer 6448 (Fig. 26).