Dakota 4WD V8-4.7L VIN N (2000)
Drive/Propeller Shaft: Adjustments
Fig. 37
Adjust the pinion shaft angle at the springs with tapered shims (Fig. 37). Install tapered shims between the springs and axle pad to correct the angle.
Refer to Steering and Suspension, for additional information.
CENTER BEARING ADJUSTMENT
Drive away shudder is a vibration that occurs at first acceleration from a stop. Shudder vibration usually peaks at the engines highest torque output.
Shudder is a symptom associated with vehicles using a two-piece propeller shaft. To decrease shudder, lower the center bearing in 1/8 inch
increments. Use shim stock or fabricated plates. Plate stock must be used to maintain compression of the rubber insulator around the bearing. Do not
use washers. Replace the original bolts with the appropriate increased length bolts