dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Front Hub - Grinding Noise Vibration|Page 4412 > < Front Hub - Grinding Noise Vibration|Page 4406
Page 1
background image

Technical Service Bulletin # 02-14-99A

Date: 991222

Front Hub - Grinding Noise Vibration

NUMBER: 02-14-99 Rev. A

GROUP: Suspension

DATE: Dec. 22, 1999

THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 02-14-99, DATED NOV. 5, 1999, WHICH SHOULD BE REMOVED FROM
YOUR FILES. ALL REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDE REVISED HUB/BEARING ASSEMBLY PART
NUMBERS.

SUBJECT:
Vibration Or Grinding Noise From Front Wheel Area

OVERVIEW:
This bulletin involves replacing the front axle hub/bearing assembly(ies) and in some cases, the steering knuckle(s).

MODELS:
2000 (AN) Dakota
2000 (DN) Durango

NOTE:

THIS BULLETIN APPLIES TO 4X4 VEHICLES BUILT BEFORE AUGUST 31, 1999 (MDH 0831XX).

SYMPTOM/CONDITION:
Vibration or grinding noise coming from the front wheel area. The vibration or grinding noise may be caused by a low mileage failure (less than 100
miles of vehicle operation) of the front axle hub/bearing assembly.

DIAGNOSIS:
If the vibration or grinding noise in the front wheel area is caused by a malfunctioning front axle hub/bearing assembly, perform the Repair Procedure.

PARTS REQUIRED:

**AR (2)

52069361AB

Assembly, Hub/Bearing, Vehicle Equipped With Rear Wheel
Antilock Brakes**

**AR (1)

52068964AE

Assembly, Hub/Bearing, Vehicle Equipped With Four Wheel
Antilock Brakes, Right Side**

**AR (1)

52068965AE

Assembly, Hub/Bearing, Vehicle Equipped With Four Wheel
Antilock Brakes, Left Side**

AR (1)

52106406AB

Knuckle, Steering, Right

AR (1)

52106407AB

Knuckle, Steering, Left

POLICY: Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

Labor Operation No:

22-45-02-98

Replace/Inspect Hub/Bearing Assemblies
And Inspect Steering knuckles

1.2 Hrs.

02-05-31-90

Replace/Inspect Hub/Bearing Assemblies
And Replace One Steering Knuckle

1.6 Hrs.

02-05-31-91

Replace/Inspect Hub/Bearing Assemblies
And Replace Both Steering Knuckles

2.0 Hrs.

FAILURE CODE: P8- New Part

Repair Procedure

1.

Raise the vehicle on a hoist.

2.

Remove the tire/wheel assembly from the side of the vehicle creating the noise.

Front Hub - Grinding Noise Vibration|Page 4412 > < Front Hub - Grinding Noise Vibration|Page 4406