Dakota 4WD V8-47L VIN N (2000) Power Window Switch Specs | Page 8095
Power Window Switch Continuity - Driver Side - Conventional Cab and Club Cab
4. Test the power window switch continuity. See the Power Window Switch Continuity charts to determine if the continuity is correct in the Neutral,
Up and Down switch positions. If OK, see Power Window Motor in the Diagnosis and Testing. If not OK, replace the faulty switch.
NOTE: The auto down feature of the driver side power window switch is controlled by an electronic circuit within the switch unit. The auto down
circuitry is activated when the driver side power window switch is moved to the second detent in the Down direction. The outputs from the auto down
circuitry are carried through the same switch pins that provide the normal down function. The auto down circuit cannot be tested. If the driver side
power window switch continuity tests are passed, but the auto down feature is inoperative, replace the faulty driver side power window switch unit.
QUAD CAB
The Light-Emitting Diode (LED) illumination lamps for all of the power window and lock switch and bezel unit switch paddles receive battery current
through the power window circuit breaker in the junction block. If all of the LEDs are inoperative in both the power window and lock switch units and
the power windows are inoperative, perform the diagnosis for Power Window System. If the power windows operate, but any or all of the LEDs are
inoperative, the power window and lock switch units with the inoperative LED(s) is faulty and must be replaced.
1. Check the circuit breaker in the junction block. If OK, go to Step 2. If not OK, replace the faulty circuit breaker.
2. Turn the ignition switch to the ON position. Check for battery voltage at the circuit breaker in the junction block. If OK, turn the ignition switch to
the OFF position and go to Step 3. If not OK, repair the circuit to the ignition switch as required.
3. Disconnect and isolate the battery negative cable. Remove the power window switch unit from the door trim panel. Unplug the wire harness
connector from the switch unit.
