Dakota 4WD V8-4.7L VIN N (2000)
1. Trim urethane adhesive from around rear glass opening fence leaving 1 - 2 mm of urethane on fence.
2. Apply PVC primer 25 mm (1 in.) wide to the mating surface of the backlite encapsulation.
3. Apply blackout primer 25 mm (1 in.) wide to the mating surface of the backlite encapsulation.
4. Apply pinchweld primer 25 mm (1 in.) wide to the backlite opening fence.
5. Apply a 10 mm (0.4 in.) bead of urethane around perimeter of backlite along the inside of the encapsulation.
6. Position backlite into backlite opening using alignment pins in lower corners.
7. Firmly push glass against rear window glass opening fence.
8. Bend tabs around edges of backlite opening fence to retain glass.
9. GClean excess urethane from exterior with Mopar~ Super Clean or equivalent.
10. Install interior trim.
