Dakota 4WD V8-4.7L VIN P Flex Fuel (2007)
4. Engage the upper edge of a trim cover (4) over the top of the turning loop. Then, squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
5. Position the seat belt (1) lower anchor to the mounting hole on the outboard side of the front seat cushion frame (2). Be certain that the seat belt
webbing between the turning loop and the lower anchor is not twisted.
6. Install the screw (3) that secures the lower anchor to the outboard side of the front seat cushion frame. Tighten the screw to 39 Nm (29 ft. lbs.).
Removal
REMOVAL
Club Cab, Without Rear Jumper Seats
1. Adjust the front seat to its most forward position.
2. Remove the outer front seat belt retractor cover.