Dakota 4WD V8-4.7L VIN P Flex Fuel (2007)
Power Distribution Module: Description and Operation
Module-Front Control
Description
DESCRIPTION
The Front Control Module (FCM) (2) is a micro controller based module located in the left front corner of the engine compartment. The FCM mates to
the Power Distribution Center (PDC) (1) to form the Integrated Power Module (IPM). The IPM connects directly to the battery and provides the primary
means of circuit protection and power distribution for all vehicle electrical systems. The front control module controls power to some of these vehicle
systems electrical and electromechanical loads based on inputs received from hard wired switch inputs and data received on the Controller Area Network
(CAN) bus circuit.
Operation
OPERATION
As messages are sent over the Controller Area Network (CAN) bus circuit, the Front Control Module (FCM) reads these messages and controls power to
some of the vehicles electrical systems by completing the circuit to ground (low side driver) or completing the circuit to 12 volt power (high side driver).
The following functions are controlled by the FCM:
-
Front turn signals
-
Stop, turn signal and tail lamps
-
Front and rear hazard warning lamps
-
Headlamps
-
Fog Lamps
-
Daytime running lamps - if equipped
-
Horn
-
Windshield and liftgate wiper and washer systems
-
Transfer case shifting
-
Trailer tow wiring output
-
Rear window defroster power and timing
The FCM provides the following features for the above function:
-
It operates the electric transfer case mechanism, replacing a stand-alone module.
-
It flashes lamps in response to turn signal, Remote Keyless Entry and Vehicle Theft Security Alarm inputs.
-
It sounds the horn in response to Remote Keyless Entry and Vehicle Theft Security Alarm inputs.
-
It turns off the horn in the event of excessively long operation that could otherwise damage the horn.
-
It minimized voltage variations to the headlamps to extend bulb life and to equalize the light output from the lamps, which might otherwise differ
due to variations in wiring resistance.
-
If the headlamps are left on, it automatically turns them off after eight minutes to protect the battery from discharge.
-
It monitors battery voltage and turns off non-essential functions such as the fog lamps, rear window defogger and heated seats if necessary to
conserve battery power.
-
It operates the high-beam headlamps at reduced intensity by pulse-width modulation of the power supply to provide the daytime running lamps.
-
It provides the variable delay intermittent windshield and liftgate wiper time delay features, and the vehicle speed sensitive windshield wiper delay
variation.
