Dakota 4WD V8-4.7L VIN P Flex Fuel (2007)
1. Position the center or the left outboard occupant buckle unit (2) onto the stud (4) near the base of the cab back panel that secures the inboard rear
seat mounting bracket to the rear floor panel (5).
2. Install and tighten the nut (3) that secures the buckle unit to the stud. Tighten the nut to 41 Nm (30 ft. lbs.). Be certain to hold the buckle in its
properly oriented position while tightening the nut.
3. Push the buckle up through the crevice between the rear seat cushion and the rear seat back.
4. Lower the rear seat cushion back to its normal seating position.
5. Engage the buckle through the elastic loop at the back of the seat cushion.
Rear - Club Cab
REAR - CLUB CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Position the lower anchor of the rear seat belt buckle (2) to the rear floor panel (4).
2. Install and tighten the screw (3) that secures the buckle anchor to the floor panel. Tighten the screw to 46 Nm (34 ft. lbs.).
3. Fold down the rear seat cushion from the cab back panel (1) to the seating position.
