Dakota 4WD V8-4.7L VIN P Flex Fuel (2007)
Starter Motor: Service and Repair
Installation
INSTALLATION
3.7L / 4.7L With Manual Trans.
1. Connect solenoid wire to starter motor (snaps on).
2. Position battery cable (1) to solenoid stud. Install and tighten battery cable eyelet nut (2). Do not allow starter motor to hang from wire harness.
3. Position starter motor (5) to transmission.
4. Install and tighten lockwasher (6) nut (8) and bolt (9).
5. Lower vehicle.
6. Connect negative battery cable.
3.7L / 4.7L With Auto. Trans.
1. Connect solenoid wire to starter motor (snaps on).
2. Position battery cable (1) to solenoid stud. Install and tighten battery cable eyelet nut (2). Refer to Torque Specifications. Do not allow starter
motor to hang from wire harness.
3. Position starter motor (4) to transmission.
4. If equipped with automatic transmission, slide cooler tube bracket into position.
5. Install and tighten both bolts (3).
6. Lower vehicle.
7. Connect negative battery cable.
