Dakota 4WD V8-5.2L VIN Y (1998)
Manifold Pressure/Vacuum Sensor: Testing and Inspection
Fig 49 MAP Sensor - Typical
NOTE: To perform a complete test of MAP sensor (Fig. 49) and its circuitry, refer to Powertrain Management/Computers and Controls/Testing and
Inspection/Diagnostic Charts. To test the MAP sensor only, refer to the following:
Fig 50 Rubber L-Shaped Fitting - MAP Sensor-to-Throttle Body
1. Inspect the rubber L-shaped fitting from the MAP sensor to the throttle body (Fig. 50). Repair as necessary.
CAUTION: When testing the MAP sensor, be sure that the harness wires are not damaged by the test meter probes.
Fig 51 MAP Sensor Connector Terminals - Typical