Dakota 4WD V8-5.2L VIN Y (1998)
Governor Pressure Sensor
6. Remove governor pressure sensor from governor body. Sensor is retained in body with M-shaped spring clip. Remove clip with small pointed tool
and slide sensor out of body.
Governor Pressure Solenoid
7. Remove governor pressure solenoid by pulling it straight out of bore in governor body. Remove and discard solenoid O-rings if worn, cut, or torn.
8. Remove transmission fluid filter.
Solenoid Harness Case Connector Shoulder Bolt
9. Remove small shoulder bolt that secures solenoid harness case connector to 3-4 accumulator housing. Retain shoulder bolt. Either tape it to
harness or thread it back into accumulator housing after connector removal.