Dakota 4WD V8-5.2L VIN Y (1998)
Typical Housing Cover With Sealant
15. Slowly tighten the nut in 6.8 Nm (5 ft. lbs.) increments until the rotating torque is achieved. Measure the rotating torque frequently to avoid over
crushing the collapsible spacer.
16. Check bearing rotating torque with an inch pound torque wrench. The torque necessary to rotate the pinion gear should be:
-
Original Bearings - 1 to 3 Nm (10 to 20 inch lbs.).
-
New Bearings - 2 to 5 Nm (15 to 35 inch lbs.).
17. Install differential in housing.
Rear Axle - 8 1/4 and 9 1/4
NOTE: The ring and pinion gears are serviced in a matched set. Do not replace the pinion gear without replacing the ring gear.
REMOVAL
1. Remove differential from the axle housing.
2. Mark pinion yoke and propeller shaft for installation alignment.
3. Disconnect propeller shaft from pinion yoke. Using suitable wire, tie propeller shaft to underbody.
4. Using Yoke Holder 6719 to hold yoke and remove the pinion yoke nut and washer.
Pinion Yoke Removal
5. Using Remover C-452, remove the pinion yoke from pinion shaft.
6. Partially install pinion nut onto pinion to protect the threads.
