Dakota Quad Cab 2WD V8-4.7L VIN N (2001)
(5) Insure the outboard pad retainer spring are seated in the caliper.
(6) Install caliper and brake pads over rotor and into adapter.
(7) Install and tighten caliper slide pins to 30 Nm (22 ft. lbs.). Start the slide pins by hand before tightening. Do not cross thread the pins.
(8) Install caliper spring into one caliper hole and under the adapter. Pull down on the opposite end of the spring and hold the end under the adapter.
With a screw driver pry up on the spring to seat the spring into the other caliper hole.
NOTE: Verify the spring is seated properly into the caliper holes.
(9) Install wheel and tire assembly.
(10) Remove support and lower vehicle.
