Dakota Quad Cab 2WD V8-4.7L VIN N (2001)
20.
Insert smaller deflectors (Fig. 2)- one on the passenger side forward flange of the heater outlet and one on the driver side rearward (Closest to the
passenger compartment) flange of the heater outlet. Snap into place until positive lock is heard.
21.
Make sure that both deflectors have tension on them and do not rattle. If they do, remove, bend appropriately and re-install.
22.
Carefully slide driver's side floor duct half (now with foam seal attached) into place. Be sure to carefully slide the duct into opening without rolling
over the foam seal. After seal is properly sandwiched between the duct half and housing, Install the two attachment screws.
23.
Slide passenger side floor duct half into place. Make sure this half properly mates with the driver's side half. Install the two attachment screws.
24.
Remove the mode actuator from the driver's side of the HVAC unit. (If vehicle is a DN, remove both mode actuators on this side.
25.
Remove cam and discard.
26.
Close the floor door and note the position of the floor door lever. Remove floor door lever and discard.
27.
Position floor door in closed position. While holding the floor door in the closed position, install new floor door lever supplied in the repair kit in
the position noted earlier. Make sure the lever snaps and locks into place.
