Dakota Quad Cab 2WD V8-4.7L VIN N (2001)
-
Ignition switch is turned to the ON position or
-
30 seconds have elapsed without any other action
Addition RKE unlock actuation before the expiration of illuminated entry will not reset timer. Opening any door before the 30 second timer
expires, will reset the entry time to 30 seconds and the illuminated entry timer will not begin counting down again until all doors are closed.
The Cargo lamps are controlled by the CTM. Placing the dome lamp switch in the cargo lamp position grounds an input to the CTM. The CTM
then sends voltage to the cargo lamps.
The Interior lamp defeat feature will riot allow any interior lamp to be turned ON. This is accomplished through an input to the CTM from the
dome lamp switch.
The CTM provides battery protection by shutting down the interior lamps due to the following.
Leaving a door open, dome lamp switch ON, reading/vanity lamp switch ON or glove box door open for more than 15 minutes while the ignition
is OFF.
POWER DOOR LOCKS/REMOTE KEYLESS ENTRY
The CTM controls the door lock actuator assemblies to handle locking and unlocking with the key fob or interior switch.
Vehicles that are equipped with the Vehicle Theft Security System will also have the central locking feature. With the central locking feature,
when the cylinder lock switch is turned to the lock position all the doors will lock. For unlocking, if the key is turned to the unlock position once,
only that door will unlock. If the key is then turned a second time to the unlock position, all the doors will unlock.
There is also a door lock inhibit feature that prevents power locking of the doors if the ignition is OFF and the key is in the ignition. Automatic or
"rolling locks" are included as a programmable feature. If the vehicle is moving approximately 15 mph and approximately 10 degrees of throttle
opening is seen by the PCM, (the PCM will send this info to the CTM via the PCI bus) indicating acceleration, the CTM will cycle the lock
actuators to lock the doors.
The higlline CTM provides for Remote Keyless Entry (RKE)
The RKE system is placed in the programming mode by the DRB III, or by the customer program features. The system will store up to four key
fob codes. Two fobs are supplied with the truck, additional fobs may be purchased through the parts department. Through the DRB III, erasing and
programming of one key fob without deleting the others is possible. If the key fob is stolen, all the fob codes stored previously may be erased to
provide the owner of the vehicle with an extra sense of security.
