Dakota Quad Cab 2WD V8-4.7L VIN N (2001)
the PARK position.
3. Place the transmission in the PARK position.
4. Lubricate seal on the solenoid and pressure switch assembly connector with petroleum jelly.
5. Position valve body in transmission and align the manual lever on the valve body to the pin on the transmission manual shift lever.
6. Seat valve body in case and install one or two bolts to hold valve body in place.
7. Tighten valve body bolts alternately and evenly to 12 Nm (105 inch lbs.) torque.
8. Install new fluid filter on valve body. Tighten filter screws to 4.5 Nm (40 inch lbs.) torque.
9. Connect the solenoid and pressure switch assembly connector.
10. Install oil pan. Tighten pan bolts to 12 Nm (105 inch lbs.) torque.
11. Lower vehicle and fill transmission with Mopar ATF +4, type 9602, fluid.
12. Check and adjust gearshift cable, if necessary.
