Dakota Quad Cab 2WD V8-4.7L VIN N (2001)
Seals and Gaskets: Service and Repair
REMOVAL - YOKE SEAL 2WD
1. Raise raise and support vehicle.
2. Mark propeller shaft and axle yoke for alignment reference.
3. Disconnect and remove propeller shaft.
4. Remove old seal with Remover C-3985-B (Fig. 127.) from transmission housing.
REMOVAL - YOKE BUSHING
1. Raise and support vehicle.
2. Mark reference lines on the propeller shaft and remove shaft.
3. Remove housing yoke seal.
4. Insert Remover 6957 into rear housing and tighten tool to bushing and remove bushing (Fig. 128).
INSTALLATION - YOKE SEAL 2WD
1. Place seal in position on transmission housing.
