Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
INSTALLATION
1. Position servo to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install servo mounting nuts and tighten to 8.5 Nm (75 in. lbs.).
5. Connect vacuum line at servo.
6. Connect electrical connector at servo.
7. Connect servo cable to throttle body. Refer to Servo Cable Removal/Installation.
8. Connect negative battery cable to battery.
9. Before starting engine, operate accelerator pedal to check for any binding.