Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
Housing Assembly HVAC: Description and Operation
HVAC HOUSING
All vehicles are equipped with a common heater- A/C housing assembly The system combines air conditioning, heating and ventilating capabilities
in a single unit housing mounted under the instrument panel.
Outside fresh air enters the vehicle through the cowl top opening at the base of the windshield, and passes through a plenum chamber to the
heater-A/C system blower housing. Air flow velocity can then be adjusted with the blower motor speed selector switch on the heater-A/C control
panel. The air intake openings must be kept free of snow, ice, leaves, and other obstructions for the heater-A/C system to receive a sufficient
volume of outside air.
It is also important to keep the air intake openings clear of debris because leaf particles and other debris that are small enough to pass through the
cowl plenum screen can accumulate within the heater-A/C housing. The closed, warm, damp and dark environment created within the heater-A/C
housing is ideal for the growth of certain molds, mildews and other fungi. Any accumulation of decaying plant matter provides an additional food
source for fungal spores, which enter the housing with the fresh air. Excess debris, as well as objectionable odors created by decaying plant matter
and growing fungi can be discharged into the passenger compartment during heater-A/C system operation.
The heater and optional air conditioner are blend- air type systems. In a blend-air system, a blend-air door controls the amount of unconditioned
air (or cooled air from the evaporator on models with air conditioning) that is allowed to flow through, or around, the heater core. A temperature
control knob on the heater-A/C control panel determines the discharge air temperature. By moving a electric actuator which operates the blend-air
door. This allows an almost immediate manual control of the output air temperature of the system.
The mode control knob on the heater-only or heater-A/C control panel is used to direct the conditioned air to the selected system outlets. The
mode control switches use an electric actuator to control the mode doors.
The optional air conditioner for all models is designed for the use of non-CFC, R-134a refrigerant. The air conditioning system has an evaporator
to cool and dehumidify the incoming air prior to blending it with the heated air. This air conditioning system uses a fixed orifice tube in the liquid
line between the condenser and the evaporator coil to meter refrigerant flow to the evaporator coil.
