dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Fuel Gauge Sender > < Diagram Information and Instructions|Page 6382
Page 1
background image

Door Switch: Testing and Inspection

WARNING:  ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE
THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO
DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable. Disconnect the door latch pigtail wire connector from the door wire harness connector. Check

for continuity between the ground circuit in the door wire harness connector and a good ground. There should be continuity. If OK, go to Step 2. If
not OK, repair the open ground circuit to ground.

2. Check for continuity between the ground circuit and the driver or passenger door ajar switch sense circuit in the door latch pigtail wire connector.

There should be continuity with the door opened, and no continuity with the door closed. If OK, go to Step 3. If not OK, replace the faulty door
latch unit.

3. Disconnect the appropriate body wire harness connector from the CTM. Check for continuity between the driver or passenger door ajar switch

sense circuit of the body wire harness connector and a good ground. There should be no continuity. If OK, go to Step 4. If not OK, repair the
shorted driver or passenger door ajar switch sense circuit between the door latch and the CTM.

4. Check for continuity between the driver or passenger door ajar switch sense circuit of the body wire harness connector and the door wire harness

connector for the door latch. There should be continuity. If OK, use a DRB III scan tool to diagnose the CTM. Refer to the appropriate diagnostic
procedures. If not OK, repair the open driver or passenger door ajar switch sense circuit between the door latch and the CTM.

Fuel Gauge Sender > < Diagram Information and Instructions|Page 6382