Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
WARNING: DURING AND FOLLOWING ANY SEAT BELT SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES,
MOUNTING HARDWARE, AND RETRACTORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY
BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS.
REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS
A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT COMPONENT.
ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED
REPLACEMENT PARTS LISTED IN THE MOPAR PARTS CATALOG.
Rear Seat Buckle/buckle Unit (CLUB OR QUAD CAB) & Lap Belt/buckle Unit (CLUB CAB ONLY)
1. Position the rear seat buckle/buckle unit (right side) or lap belt/buckle unit (left side) onto the rear floor panel.
2. Install and tighten the screw that secures the anchor plate of the rear seat buckle/buckle unit (right side - club cab or quad cab) or lap belt/buckle
unit (left side - club cab only) to the rear floor panel. Tighten the screw to 40 Nm (29 ft. lbs.).
3. Reinstall the rear seat onto the rear floor panel (club cab) or fold down the rear seat cushion (quad cab).
Rear Seat Lap Belt Unit - Left Side - QUAD CAB ONLY
1. Position the rear seat lap belt unit onto the stud on the inboard side of the left center rear seat riser bracket.
2. Install and tighten the nut that secures the rear seat lap belt anchor plate to the stud on the inboard side of the left center rear seat riser bracket.
Tighten the nut to 40 Nm (29 ft. lbs.).
3. Fold down the rear seat cushions.
Rear Seat Buckle Unit - Left Side - QUAD CAB ONLY
1. Position the rear seat belt buckle unit onto the rear of the left seat cushion frame.
2. Install and tighten the screw that secures the rear seat belt buckle anchor plate to the rear of the left seat cushion frame. Tighten the screw to 40
Nm (29 ft lbs).
3. Fold down the rear seat cushions.
