Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
Suspension Strut / Shock Absorber: Service and Repair
SHOCK
REMOVAL
1. Remove the upper shock nut, retainer and grommet from the shock absorber stud.
2. Raise and support the vehicle.
3. Remove the lower mounting bolts and remove shock absorber through the lower suspension arm.
INSTALLATION
NOTE: Upper shock nut must be replaced or use Mopar Lock 'N Seal or Loctite 242 on existing nut.
1. Install the lower retainer (lower retainer is stamped with a L) and grommet on the shock absorber stud and extend the shock. Insert the shock
absorber through the lower suspension arm and upper mounting hole.
2. Install the lower mounting bolts and tighten to 28 Nm (21 ft. lbs.).
3. Remove support and lower the vehicle.
4. Install the upper grommet and retainer (upper retainer is stamped with a U) on the shock absorber stud. Install a new nut or use Mopar Lock 'N
Seal or Loctite 242 on existing nut and tighten to 26 Nm (19 ft. lbs.).
