Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
Pinion Gear: Service and Repair
Rear Axle - 8 1/4
8 1/4 Inch REAR AXLE - PINION GEAR/RING GEAR/ TONE RING
REMOVAL
NOTE: The ring gear and pinion are serviced in a matched set. Never replace one gear without replacing the other matching gear.
1. Remove differential from the axle housing.
2. Mark the companion flange and propeller shaft for installation alignment.
3. Disconnect propeller shaft from the companion flange and tie propeller shaft to underbody.
4. Place differential case in a suitable vise with soft metal jaw protectors. (Fig. 47).
5. Remove ring gear bolts from the differential case.
6. Drive ring gear off the differential case with a rawhide hammer (Fig. 47).
7. Install bolts into two of the threaded holes in the companion flange 180° apart.
8. Position Holder 6719 against the companion flange and install a bolt and washer into one of the remaining threaded holes. Tighten the bolts so the
Holder 6719 is held to the flange.
9. Hold companion flange with Holder 6719 and remove companion flange nut and washer.
