Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
1. Install propeller shaft with all reference marks aligned.
2. Loosely install bolts to C/V and transfer case companion flange.
3. Install bolts to companion flange and flange yoke and tighten to 108 Nm (80 ft. lbs.).
4. Tighten bolts to transfer case companion flange to 30.5 Nm (22.5 ft. lbs.).
5. Install skid plate, if equipped.
6. Lower vehicle and road test to verify repair.
Standard Procedure - Propeller Shaft Angle
STANDARD PROCEDURES - PROPELLER SHAFT ANGLE
To accurately check driveline alignment, raise and support the vehicle at the axles as level as possible. Allow the wheels and propeller shaft to turn.
PROPELLER SHAFT ANGLE
1. Remove any external bearing snap rings, if equipped, from universal joint so protractor base sits flat.
2. Rotate the shaft until transmission/transfer case output yoke bearing is facing downward.
NOTE: Always make measurements from front to rear and from the same side of the vehicle.
3. Place Inclinometer 7663 (J-23498A) on yoke bearing (A) parallel to the shaft (Fig. 4). Center bubble in sight glass and record measurement.
NOTE: This measurement will give you the transmission or Output Yoke Angle (A).
