Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
Power Window Switch: Service and Repair
REMOVAL
The driver side power window switch is included with the Drive Door Module. (Refer to DOOR MODULE - REMOVAL) for the service procedures.
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick, start at the rear of the switch bezel and pry up from door trim panel.
3. Disconnect the wire harness connector from switch.
4. Remove switch from bezel.
INSTALLATION
The driver side power window switch is included with the Drive Door Module. (Refer to DOOR MODULE - INSTALLATION) for the service
procedures.
1. Install switch to bezel.
2. Connect wire harness connector to switch.
3. Insert the front of the switch into the door trim panel first, then press into position.
4. Connect the battery negative cable.